.webp)
EV-TEST100 in combination with appropriate HT multifunction instrument simulates an electric vehicle connected to the charging station, allowing you to verify the EVSE full functionality and electrical safety. EV-TEST100 is able to test charging stations with charging modes 2 and 3 and Type 2 connector (European standard).
| Use for EVSE charging stations |
Charging modes 2 and 3 |
|---|---|
| Test cable with connector |
Type 2 (IEC 62196-2) |
| Vehicle simulation via Control Pilot (CP state) |
States A, B, C, D |
| Simulating the current capacity of Proximity Pilot (PP state) |
NC, 13A, 30A, 32A, 63A |
| Fault condition simulation on PE |
FAULT PE |
| Diode simulation in short circuit |
FAULT E |
| EVSE internal counter efficiency check |
LOAD |
| Input voltage |
Max 415V AC, Phase-Phase, 50 / 60Hz |
| External load L-N-PE |
240V 50/60Hz, Max 10A AC |
| CP signal |
PWM 12V |
| External load protection |
Fuse FF 10A / 250V, 5x20mm |
| Operating temperature |
0°C ÷ 40°C |
| Operating humidity |
<80&RH |
| Guidelines |
IEC/EN60364-7-722 |
